With craftsman’s spirit, SBM always tries to do better.

Toggle Navigation

Mineral Grinding Machine Made In Thailand

Psted On 2018-10-17 16:33:10
Mineral Grinding Machine Made In Thailand

How to effectively control the fineness while taking into account efficiency

In order to have a high return on investment, in addition to high efficiency, it is required to have high quality of finished products, that is to say, these two aspects need to be considered at the same time, so how to effectively control the production process of Mineral Grinding Machine What about these two aspects?

In order to take into account both the fineness and efficiency of the finished product, it is necessary to find factors that affect both of these aspects at the same time, so that reasonable prevention can be achieved and the high yield can be realized. We pass the Mineral Grinding Machine. The analysis of the production process can be found that the factors affecting the efficiency and quality of the finished product are mainly as follows:

Factor 1, ore hardness

Because different Mineral Grinding Machines have different processing capabilities, if the hardness of the ore meets the production process of the machine, the production will be smoother, not only high efficiency, but also the quality of the finished product. Otherwise, two All of them are affected and do not meet the production requirements of customers. In view of this situation, it is necessary to properly handle the ore blending in production, to make the ore size as uniform as possible, and the ratio of bulk and powder minerals is reasonable and stable; p>

Factor 2, blade wear

For the production process of the Mineral Grinding Machine, if the blade is worn out, the separation process of the material cannot be carried out very well. At this time, the coarse particles in the finished product will be caused, and the blade will be Wear and tear will affect the life of the analyzer. If this phenomenon is not handled in time, it will cause the production of the machine to be impossible;

Factor 3, classifier opening

For the installation process of the Mineral Grinding Machine, some customers did not adjust the size of the classifier opening when it was in progress, and the operator did not pay much attention during the operation, which would affect the grinding operation invisibly. Generally speaking, the lower opening of the classifier is large, and the sedimentation area of ​​the ore is large, so the amount of sand returning increases, and the fineness of the grinding is relatively fine, and if. The opening of the classifier is large, the sedimentation area of ​​the ore is large, and the water flow is relatively gentle, so the amount of sand returning increases, and the fineness of the grinding is relatively fine. Similarly, if the opening of the classifier of the Mineral Grinding Machine is low and large, the amount of sand returned Increase, the grinding fineness is relatively thin, otherwise, the grinding fineness becomes thicker;

Factor 4, classifier overflow height

The level of overflow weir of the Mineral Grinding Machine classifier affects the size of the sedimentation zone of the ore. Therefore, in production, it is possible to appropriately adjust the level of the overflow of the classifier according to the requirements of the fineness of the grinding. If the grinding fineness is required to be fine, a certain height of angle iron can be welded on both sides of the classifier, and the level of the overflow of the classifier can be adjusted by inserting the wood board. Sometimes the long-term accumulation of slime can naturally increase the height of the weir;

Factor 5, broken particle size

In the production process of Mineral Grinding Machines, the staff must supervise the crushing system. If the particle size of the Mineral Grinding Machine changes during production, it must be immediately fed back to the crushing workshop. The general requirement is that the finer the crushing particle size, the better, and the “breaking and grinding less” saves production costs.